DTC No. | Detecting Condition | Possible Cause | Related engine |
P1692 | Immobilizer indicator lamp error | Immobilizer indicator lamp error (Cluster) | D2.0, β2.0 |
PROBLEM VERIFICATION
Connect the hi-scan (pro) to data link connector.
Turn the ignition switch to ON and verify the DTC "P1692" is displayed.
Erase the DTC "P1692" with the hi-scan (pro) and then monitor again.
Is the same code displayed ?
▶ Problem is intermittent and engine control module memory was not cleared.
▶ Check cluster and ECM connectors
CHECK CLUSTER AND ECM CONNECTORS
Thoroughly check connectors for loose, poor connection, bent, corrosion, contamination, deterioration, or damage.
Are all connectors good?
▶ Repair or replace it.
▶ Check for open in harness
CHECK FOR OPEN IN HARNESS
Turn ignition switch to OFF and disconnect Cluster and ECM connectors.
Measure resistance between the terminals 7 of Cluster harness connector (M15-3) and (17/81) of ECM harness connector (C230-1/C130-1).
Specification: below 1Ω
Does each resistance indicate continuity?
▶ Repair open in harness.
▶ Replace the cluster
REPLACE THE CLUSTER
Temporarily install a good cluster.
Is operating of the immobilizer lamp possible?
▶ Replace the cluster.
▶ Proceed with ECM problem procedure.
