Lift the vehicle, and make sure it is securely supported.

Remove the rear tire and wheel.

Remove the plug from the disc.

Turn the adjusting wheel in arrow direction as shown until the disc won’t be rotated by tangential force of 29.4N(3kgf, 6.6Ib) using the (-)screw driver (A). Then turn back the adjusting wheel by 5 notches.

Install the rear tire and wheel after installing the plug.

Lift the vehicle, and make sure it is securely supported.

Remove the floor console. (Refer to BD Gr. - "Floor console")

After the full stroke operation of the brake lever over 3 times for setting the cable, the travel must be between 9 notches when applying a force of 196N(20kgf, 44Ib) at 40mm from the end of lever assembly (excluding button) by adjusting nut (A).

Release the parking brake lever fully, and check that parking brakes do not drag when the rear wheels are turned. Readjust if necessary.

Make sure that the parking brakes are fully applied when the parking brake lever is pulled up fully.

Parking indicator lamp must be “OFF”when the lever assembly is released. It must be “ON” when the lever assembly is operated by 1 notch.

Install the floor console. (Refer to BD Gr. - "Floor console")

Remove the floor console.

Loosen the adjusting nut (A) and the parking brake cables.

Disconnect the connector(A) of the parking brake switch.

Remove the 4 bolts and parking brake lever assembly(A).

Remove the wheel and tire.

Remove the brake drum and the brake shoe (Refer to the rear drum brake).

Remove the parking brake cable(A) from the brake shoe.

Remove the parking brake cable retaining ring (B), from the parking brake cable (A).

Install the removed parts in the reverse order of removal.

Apply the specified grease to each sliding parts of the ratchet plate or the ratchet pawl.

After installing the parking brake cable adjuster, adjust the parking brake lever stroke (Refer to the parking brake check and adjustment).