3.
Disconnect the remocon switch connector(A).
Disconnect the battery negative cable, then disconnect the positive cable, and wait at least three minutes.
Remove the driver's airbag (See page RT group-air bag module).
Disconnect the remocon switch connector(A).
Check the continuity between the terminals of the connector in each switch position according to the table.
If there is continuity, and it matches the table, the switch is O.K.
If there is no continuity, replace the remocon switch.
Disconnect the connector(A) from the brake switch.
Remove the brake switch(B).
Check for continuity between the terminals according to the table.
If necessary, replace the switch or adjust the pedal height.
Check that the actuator cable (A) moves smoothly with no binding or sticking.
position, M/T in neutral) until the radiator fan comes on, then let it idle.
Measure the amount of movement of the output linkage (B) until the engine speed starts to increase.
At first, the output linkage should be located at the fully closed position (C). The free play (D) should be 3.75±0.5 mm (0.15±0.02 in.)
If the free play is not within specs, move the cable to the point where the engine speed starts to increase, and tighten the locknut (A) and adjusting nut (B).
Turn the adjusting nut (A) until it is 3.75±0.5 mm (0.15±0.02 in.) away from the bracket (B).
Pull the cable so that the adjusting nut (A) touches the bracket, and tighten the locknut (B).
Loosen the locknuts(A) and disconnect the actuator cable (B) from the throttle linkage(C).
Damage to the auto cruise cable or the accelerator cable may result if the throttle lever is rotated by lifting up on the cable.
When connecting the auto cruise cable from the throttle lever, rotate the throttle lever only by lifting up on the lever itself.
Disconnect the cover, actuator cable and connector.
Loosen the three mounting bolts(E), and remove the actuator(F) with the bracket.
Installation is the reverse of removal.
Disconnect the battery negative cable, them disconnect the positive cable, and wait at least three minutes.
Remove the driver's airbg (See page RT group-air bag module).
Disconnect the remocon switch connector(A).
Loosen the two mounting screws(B), and remove the cruise remocon switch(C).
Installation is the reverse of removal.
Connect the battery positive cable and negative cable to the battery.
