2.
Remove the head lamp mounting bolts (2EA), then disconnect the lamp connectors.
Disconnect the negative(-) battery terminal.
Remove the head lamp mounting bolts (2EA), then disconnect the lamp connectors.
Replace the head lamp bulb(A), position bulb(B) and turn signal bulbs(C).
Installation is the reverse of removal.
The head lamps should be aimed with the proper beam-setting equipment, and in accordance with the equipment manufacturer's instructions.
If there are any regulations pertinent to the aiming of head lamps in the area where the vehicle is to be used, adjust so as to meet those requirements.
Inflate the tires to the specified pressure and remove any loads from the vehicle except the driver, spare tire, and tools.
The vehicle should be placed on a flat floor.
Draw vertical lines (Vertical lines passing through respective head lamp centers) and a horizontal line (Horizontal line passing through center of head lamps) on the screen.
With the head lamp and battery in normal condition, aim the head lamps so the brightest portion falls on the horizontal and vertical lines.
Make vertical and horizontal adjustments to the lower beam using the adjusting wheel.
Turn the low beam on without driver aboard.
The cut-off line should be projected in the allowable range (shaded region).
Turn the front fog lamp on without driver aboard.
The cut-off line should be projected in the allowable range (shaded region).
Pull out the head lamp relay(Low) (A) and head lamp relay (High) (B) from the engine compartment relay box.
Check for continuity between terminals.
