2.
After loosening the seat assembly mounting bolt and nut, remove the seat assembly (B).
Remove the seat assembly mounting cover (A).
After loosening the seat assembly mounting bolt and nut, remove the seat assembly (B).
Open the connector box (A).
Disconnect the connector (B), and remove the seat assembly.
Installation is the reverse of removal.
SEAT MOUNTING BOLT INSTALLATION PROCEDURE.
Set the seat into the most rearward.
Check each slide for lock, and then tighten the front mounting bolt temporarily.
Set the seat into the most forward.
Check each slide for lock, and then tighten the rear mounting bolt completely.
Set the seat into the most rearward.
Check the front mounting bolt completely.
Check that the seat operates to and fro smoothly
and all the locking portion locks properly.
Loosen the lumbar support lever mounting screw, remove the lumbar support lever (A).
Installation is the reverse of removal.
Remove the height adjuster knob (A) and recliner knob (B).
Loosen the recliner mounting screw and clip, then remove the recliner cover (C).
Remove the lumbar support lever (See page BD- 84).
After disconnecting the scuff band (A),remove the seat back panel (B).
Disconnect the protector (A) from the back frame, then open the zipper (B).
Remove the headrest and headrest guide(A).
After removing the hogring clips (A) on the front of seat back and remove the seat back cover (B).
When removing the hogring clip, remove the hogring clip with pressing the wire not to separate the wire from the sponge.
Installation is the reverse of removal.
To prevent wrinkles, make sure the material is stretched evenly over the cover (B) before securing the hogring clips (A).
Replace the hogring clips with new ones using special tool (C).
Remove the seat assembly (See page BD- 84).
Disconnect the scuff band.
Remove the connector box (A).
Remove the connectors (A).After loosening the mounting bolts,remove the cushion (B)
Disconnect the protector (A) from the cushion frame (B).
After removing the hogring clips (A) on the front of seat back and remove the seat back cover (B).
When removing the hogring clip, remove the hogring clip with pressing the wire not to separate the wire from the sponge
Installation is the reverse of removal.
To prevent wrinkles, make sure the material is stretched evenly over the cover (B) before securing the hogring clips (A).
Replace the hogring clips with new ones using special tool (C).
Remove the lumbar support lever (See page BD- 84).
Remove the seat back panel (See page BD- 87).
Remove the headrest guide (See page BD- 86).
Remove the seat back cover and pad from the frame.
Loosen the mounting bolts,then remove the seat back frame(A).
Remove the side air bag for replacing side air bag installation seat.
Bdfore service, be fully aware of precautions and service procedure relevant to air bag
(See page RT- "Airbag").
Installation is the reverse of removal.
After removing the seat back panel, disconnect the protector and open the zipper.
Remove the seat back assembly (A).
Remove the seat cushion (See page BD- 87).
Remove the recliner cover,recliner knob and height adjuster knob (See page BD- 85).
Remove the seat track (A)
Installation is the reverse of removal.
Remove the seat back cover (See page BD- 85).
Cut the heater (A) attached to the pad (B), as shown in the picture.
Take off the paper from the the backside of the heater assembly.
Attch the heater to the main part of pad
Be sure to match the heater with main apperance.
Install the seat back cover.
Remove the seat cushion cover (See page BD- 87).
Cut the heater (A) attached to the pad (B), as shown in the picture.
Take off the paper from the the backside of the heater assembly.
Attach the heater to the main part of pad
Be sure to match the heater with main apperance.
Install the seat cushion cover.
