Remove the shift lever knob(A).

Remove the console cover(B), disconnecting the shift lever connector(A).

Seperate the lever assembly(B) from the facia bracket assembly(A).

Disconnect the cable interlinked to lever assembly.

In case of 4WD vehivle, discconnect the 4WD ECM connector(A).

Remove the facia bracket assembly.

Install the facia bracket assembly.

In case of 4WD vehicle, connect the 4WD ECM connector(A).

Connect the cable interlinked to lever assembly.

Install the lever assembly(B) to the facia bracket assembly(A).

Install the console cover(B) fixing the shift lever connector(A) on it.

Install the lever conver(B) completely connecting the terminals.

Install the shift lever knob(A).

With shift lever at P position and brake pedal not depressed. Push button cannot be operated. (Shift lever cannot be shifted to other positions from P) Push button can be operated at the positions except P.

With IG key at the position other than "LOCK" (May be at "ACC") and brake pedal stroke 15~25mm (With shift lever at P position). Push button can be operated and shift lever can be shifted smoothly to other from P.

With brake pedal not depressed. Shift lever can be shifted smoothly to "P" positions from other positions.

Brake pedal must be operated smoothly without catching at all positions.

Check that each lock cam is shown below.

Install shift lock cable in position according to this DWG. In this case, shift lock cable must be fixed to brake pedal in position.

Temporarily install shift lock cable to A/T lever assy as shown below. Securely insert cable end into fixing point of shift lock cam.

Doing the work of 3. slightly pull outer casing of shift lock cable to direction "E" to stretch cable. In this case, shift lock cam must not move.

After checking portion of cable end touches cable fixing pin of shift lock cam. Fix outer casing with a nut.

Check the installation condition of the shift lock cam.