8168202

Check coil antenna.

(1)

Ignition "OFF".

(2)

Disconnect SMARTRA connector.

(3)

Measure resistance between antenna coil(+) and (-) terminal of SMARTRA harness connector.

Specification : Approx 8.5 Ω

(4)

Is the measured resistance within specifications ?

	▶ Go to "Check SMARTRA" procedure.
	▶ Check for open or short in antenna coil. Repair as necessary and go to "Verification of Vehicle Repair" procedure.

Check SMARTRA.

(1)

IGN "ON" & Engine "OFF".

(2)

Neutralize Both "SMARTRA" and "PCM/ECM" and Register transponder key by scantool.

note

Pin code is required to Neutralize SMARTRA and to Register transponder key

(3)

Are Neutralizing and Registering completed normally ?

▶ Perform all the key teaching procedure with scantool. (All the keys must be retaught) and then, go to "Verification of Vehicle Repair" Procedure.

▶ Substitute with a known-good SMARTRA and Perform Key teaching procedure.

▶ If the problem is corrected, replace SMARTRA and then go to "Verification of Vehicle Repair" procedure.