2.
Remove the control cable (A).
Remove the center console assembly.
(Refer to Body - "Console")
Remove the control cable (A).
Remove the control cable assembly in the vehicle after removing the nuts (B) and the retainer (A).
Tightening torque:
11.8 ~ 14.7 N.m (1.2 ~ 1.5 kgf.m, 8.7 ~ 10.9 lb-ft)
Remove the nut (C).
Tightening torque:
9.8 ~ 13.7 N.m (1.0 ~ 1.4 kgf.m, 7.2 ~ 10.1 lb-ft)
Remove the cable (B) from the bracket (A) at transaxle assembly side.
Remove the control cable inside of cab.
Installation is the reverse of removal.
Make sure vehicle does not roll before setting room side shift lever and T/M side manual control lever to "N" position.
Make sure vehicle does not roll before setting room side shift lever and T/M side manual control lever to "N" position.
Commect room side lever (A) and control cable (B).
Push cable to "F" direction shown to eliminate FREE PLAY.
Tighten adjusting nut (A).
Tightening torque:
9.8 ~ 13.7 N.m (1.0 ~ 1.4 kgf.m, 7.2 ~ 10.1 lb-ft)
After adjusting, check to be sure that this part operates as designed at each range of T/M side corresponding to each position of room lever.
