2.
Disconnect the clutch tube (B) and reservoir hose (A) from the clutch master cylinder.
Do not spill brake fluid on the vehicle; it may damage the paint if brake fluid does contact the paint, wash it off immediately with water.
Remove the battery and ECM.
(Refer to "Manual transaxle system" in MT group)
Disconnect the clutch tube (B) and reservoir hose (A) from the clutch master cylinder.
Disconnect the push rod from the master cylinder by removing the snap pin (A) and washer (B).
Remove the clutch pedal mounting bolt (A) and nuts (B-2ea).
Tightening torque:
(A) 16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~ 18.8 lb-ft)
(B) 18.6 ~ 23.5 Nm (1.9 ~ 2.4 kgf.m, 13.7 ~ 17.4 lb-ft)
Disconnect the ignition lock switch connector (C) and clutch switch connector (B).
Remove the clutch pedal and the master cylinder assembly together.
