2.
Disconnect the ECM Connector (A).
When replacing the ECM, the vehicle equipped with the immobilizer must be performed procedure as below.
[In the case of installing used ECM]
1) Perform "ECM Neutral mode" procedure with GDS.
(Refer to Body Electrical System - "Immobilizer")
2) After finishing "ECM Neutral mode", perform "Key (Refer to Body Electrical System - "Immobilizer")
(Refer to "Immobilizer" in BE group)
[In the case of installing new ECM]
Perform "Key teaching" procedure with GDS.
(Refer to Body Electrical System - "Immobilizer")
When replacing the ECM, the vehicle equipped with the smart key system (Button start) must be performed procedure as below.
[In the case of installing used ECM]
1) Perform "ECM Neutral mode" procedure with GDS.
(Refer to Body Electrical System - "Smart Key System")
2) After finishing "ECM Neutral mode", insert the key (or press the start button) and turn it to the IGN ON and OFF position. Then the ECM learns the smart key information automatically.
[In the case of installing new ECM]
Insert the key (or press the start button) and turn it to the IGN ON and OFF position. Then the ECM learns the smart key information automatically.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
Disconnect the ECM Connector (A).
Remove the battery.
(Refer to Engine Electrical System - "Charging System")
Remove the mounting bolt and then remove the ECM & bracket (A).
