Component Inspection
■ Check resistance of Cold start solenoid valve
1.

Ignition "OFF"

2.

Disconnect Cold start solenoid valve connector.

3.

Measure resistance between power and control terminals of Cold start solenoid valve.

Specification : Approx. 21 Ω ± 5% ( 23℃ , 73.4℉)

4.

Is resistance within the specification?

▶ Go to next step as indicated below

▶ Replace Cold start solenoid valve and then go to "Verification of Vehicle Repair" procedure

Circuit Inspection
1.

IG KEY "OFF".

2.

Disconnect Cold start solenoid valve & PCM connect

3.

Measure the resistance between the control terminals of Cold start solenoid valve and PCM.

Specification : Below 1Ω

4.

.Is resistance within the specification?

▶ Go to next step as indicated below

▶ Repair the control wiring and than go to " Verification of Vehicle Repair " procedure.

Яндекс.Метрика