1.
Loosen the mounting screws, then remove the sunvisor (A) and retainer (B).
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Put on gloves to protect your hands.
Loosen the mounting screws, then remove the sunvisor (A) and retainer (B).
Install in the reverse of removal.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Put on gloves to protect your hands.
Remove the covers (A) and screws, then remove the assist handle (B).
Install in the reverse of removal.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Put on gloves to protect your hands.
Using a screwdriver or remover, remove the room lamp cover (B).
After loosening the mounting screws, then remove the room lamp (A).
Disconnect the connector (A).
Install in the reverse of removal.
Make sure the connectors are plugged in properly.
Using a screwdriver or remover, remove the vanity lamp (A).
Disconnect the vanity lamp connector (B).
Install in the reverse of removal.
Make sure the connector is plugged in properly.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Put on gloves to protect your hands.
After loosening the mounting screws, then remove the overhead console assembly (A).
Disconnect the connectors (A).
Install in the reverse of removal.
Make sure the connectors are plugged in properly.
Put on gloves to protect your hands.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.
Remove the following items:
Front seat
(Refer to the BD group - "Front Seat")
Rear seat
(Refer to the BD group - "Rear Seat")
Floor console
(Refer to the BD group - "Console")
Sunvisor
Vanity lamp
Room lamp
Assist handle
Overhead console
Front pillar trim
(Refer to the BD group - "Interior Trim")
Front door scuff trim & Rear door scuff trim
(Refer to the BD group - "Interior Trim")
Canter pillar lower trim
(Refer to the BD group - "Interior Trim")
Canter pillar upper trim
(Refer to the BD group - "Interior Trim")
Wheel house trim
(Refer to the BD group - "Interior Trim")
Rear pillar trim
(Refer to the BD group - "Interior Trim")
Remove the ECM mirror cover (A).
Disconnect the ECM mirror connector (B).
Remove the auto defog sensor cover (A).
Disconnect the auto defog sensor connector (B).
Remove the rain sensor cover (A).
Disconnect the rain sensor connector (B).
Disconnect the roof trim main connector (A).
Disconnect the sunroof motor connector (A).
Detach the clips, then remove the roof trim (A).
Install in the reverse of removal.
Replace any damaged clips.
Make sure the connector is plugged in properly.
