1.
Disconnect the push rod from the master cylinder by removing the snap pin (A) and washer (B).
Do not spill brake fluid on the vehicle; it may damage the paint if brake fluid does contact the paint, wash it off immediately with water.
Disconnect the push rod from the master cylinder by removing the snap pin (A) and washer (B).
Remove the battery.
(Refer to Engine Electrical System - "Battery")
Remove the ECM.
(Refer to Engine Control System - "ECM")
Remove the fuel filter. [Diesel]
(Refer to Fuel System - "Fule Filter")
Disconnect the clutch tube (B) and reservoir hose (A) from the clutch master cylinder.
Remove the clutch master cylinder assembly (A) by turning it clockwise.
Install in the reverse order of removal.
Perform bleeding air procedure in clutch release cylinder after pouring the brake fluid.
(Refer to Clutch System - "Clutch Release Cylinder ")
