Many malfunctions in the electrical system are caused by poor harness(es) and terminals. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.

Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.

Has a problem been found?

	▶ Repair as necessary, go to "Verification of Vehicle Repair" procedure.
	▶ Go to "Front Right Turn Signal Lamp Circuit Inspection" as below.

IG key "OFF", disconnect battery (-) terminal.

Disconnect SJB connector and *the turn signal lamp FR connector.

Measure resistance between *the turn signal lamp FR terminal of "SMART JUNCTION BOX" harness connector and chassis ground.

Is the measured resistance within specification?

	▶ Substitute with a known-good SJB and check for proper operation. If the problem is corrected, replace the SJB and go to "Verification of Vehicle Repair" procedure.
	▶ Repair short to ground in the turn signal lamp FR circuit, and go to "Verification of Vehicle Repair" procedure.