PCM sets DTC P0222 if the PCM detects signal voltage lower than the possible range of a properly operating TPS2.
Item | Detecting Condition | Possible Cause | |
DTC Strategy |
•
Short to Ground or Open circuit | 1. Open in power supply harness or signal harness 2. Short to ground in power supply or signal harness 3. Poor connection or damaged harness 4. Faulty TPS2 | |
Case1 | Enable Conditions |
•
Ignition "ON" | |
Threshold Value |
•
TPS2 < 0.1V | ||
Case2 | Enable Conditions |
•
Ignition "ON"
•
In idle status
•
Target throttle angle < 58%
•
MAF Limphome detected or TPS1 failure detected | |
Threshold Value |
•
TPS2 at idle < 2.0V | ||
Diagnostic Time |
•
0.05 sec. | ||
MIL On Condition |
•
1 driving cycle | ||
Limp-Home |
•
Forced limited power mode : When the DTC is set, the PCM reduces engine torque by 25% of normal value.
•
The PCM uses TPS1 signal to monitor the controlled opening angle of the throttle valve. | ||
