4.
Is resistance within the specification?
 | ▶ Go to next step as indicated below |
 | ▶ Repair the control wiring and than go to " Verification of Vehicle Repair " procedure. |
IG KEY "OFF".
Disconnect the Sub fuel pump relay & PCM connect
Measure the resistance between the control terminals of Sub fuel pump relay and PCM.
Specification : Below 1Ω
Is resistance within the specification?
| ▶ Go to next step as indicated below |
| ▶ Repair the control wiring and than go to " Verification of Vehicle Repair " procedure. |
Many malfunctions in the electrical system are caused by poor harness(es) and terminals. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.
Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
Has a problem been found?
| ▶ Repair as necessary and go to "Verification of Vehicle Repair" procedure. |
| ▶ Check valve timing. Refer to "P0016 : Crankshaft Position-Camshaft Position Correlation(Bank1)" procedure. Repair as necessary and go to "Verification of Vehicle Repair" procedure |
