3.
Monitor the "Current Data" to "ECU, KEY and Smartra STATUS' Parameter on the GDS.
Specification : 'LEARNT'
Fig.1) This data show that 2 keys have been taught, ECU has been learnt, Key in key cylinder has been learnt and SMARTRA3 has been learnt.
Connect GDS to Data Link Connector(DLC).
IG "ON" & Engine "OFF".
Monitor the "Current Data" to "ECU, KEY and Smartra STATUS' Parameter on the GDS.
Specification : 'LEARNT'
Fig.1) This data show that 2 keys have been taught, ECU has been learnt, Key in key cylinder has been learnt and SMARTRA3 has been learnt.
Have the both "ECM, KEY and Smartra STATUS' been learnt ?
 | ▶ Check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, damage on the PCM/ECM or SMARTRA. And has not erased this DTC which is not erased previous repair. Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure. |
 | ▶ Check for open or short in antenna coil. Substitute with a known-good antenna Coil and check for proper operation. and then go to "Verification of Vehicle Repair" procedure. |
