9879607

Vehicle Parked & Ignition ON.

Connect GDS and select "DTC Analysis" mode.

Click "DTC Status" on the "Diagnostic Trouble Codes(DTC)" menu bar to see DTC's information.

Confirm that "DTC Readiness Flag" indicates "COMPLETED". If not, drive the vehicle within conditions noted in the freeze frame data or enable conditions.

Read "DTC Status" parameter.

Is parameter displayed "Present fault"?

	▶ Go to Next procedure.
	▶ This fault was repaired and TPMS Module memory was not cleared. Go to "Verification of Vehicle Repair" procedure.

Connect GDS and select "Data Analysis" mode.

Monitor data of TPMS Sensor parameter on the "Current Data".

After driving at 25 KPH(15 MPH) for approx. 10~20 minutes

Check that current data is correctly displayed while driving.

Measuring method : Refer to No.1 Measurement

No.1) A method of checking a sensor ID with VCI

■ Check a sensor's value out of sensor's information.

Fig.1) Data displayed by TPMS Module

Current data is normally displayed?

▶ Fault is intermittent. It has been repaired and TPMS Module memory is not cleared yet.

▶ Go to "Verification of vehicle Repair" procedure.

▶ Check if the TPMS sensor which is not fitted with the vehicle specifications is installed.

▶ Substitute with a known-good TPMS Module and check for proper operation. If problem is corrected, replace TPMS Module and then go to "Verification of Vehicle Repair" procedure.

▶ After replacing with a known-good TPMS Module, you must do the 'Vehicle Name Writing', 'VIN Writing' and 'Register Sensor' at the "Vehicle S/W Management" mode by using GDS and GDS TPMS.