1.
Using a screwdriver or remover, remove the crash pad center garnish (A).
Put on gloves to protect your hands.
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.
Using a screwdriver or remover, remove the crash pad center garnish (A).
Using a screwdriver or remover, remove the gear boot (A).
After loosening the mounting screws, then remove the console upper cover (A).
Disconnect the multimedia jcak connectors (A).
Using a screwdriver or remover, remove the parking brake cover (A).
Remove the console tray mat (A).
After loosening the mounting screws and bolts, then remove the floor console assembly (A).
After loosening the mounting screws, bolts, clips, then remove the console side cover (A).
Disconnect the connector (A).
Install in the reverse of removal.
Make sure the connectors are connected in properly.
Replace any damaged clips.
A plastic trim tool is recommended, but if prying with a screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Put on gloves to protect your hands.
Using a screwdriver or remover, remove the crash pad center garnish (A).
Remove the gear knob (A) and gear boots (B) pull both of it up.
After loosening the mounting screws, remove the console upper cover (A).
Disconnect the connector (A).
Using a screwdriver or remover, remove the parking brake cover (A).
Remove the console tray mat (A).
After loosening the mounting screws and bolts, then remove the floor console assembly (A).
After loosening the mounting screws, bolts, clips, then remove the console side cover (A).
Disconnect the connector (A).
Install in the reverse of removal.
Make sure the connectors are connected in properly.
Replace any damaged clips.
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Put on gloves to protect your hands.
Using a screwdriver or remover, remove the rear console cover (A).
After loosening the mounting screws, then remove the armrest assembly and armrest support bracket (A).
After loosening the mounting screws, then disconnect the armrest assembly (A) and armrest support bracket (B).
Install in the reverse of removal.
Replace any damaged clips.
