4.
Remove the installation bolt (C), and then remove the valve from the ETC module.
Turn the ignition switch OFF.
Disconnect the Cold Start Solenoid Valve connector.
Measure resistance between Cold Start Solenoid Valve terminals 1 and 2.
Specification: Refer to "Specification"
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
Disconnect the Cold Start Solenoid Valve connector (A).
Disconnect the fuel hoses (B) from the valve.
Remove the installation bolt (C), and then remove the valve from the ETC module.
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped.
In this case, use it after inspecting.
Be careful of foreign material not to flow into the valve.
Install in the reverse order of removal.
Cold Start Solenoid Valve installtion bolt: 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
