5.
Monitor change of current data.
Fig 1) Normal current data
caution
This current data is nothing but an example at certain condition. Thus, the real current data could be different from this example.
Connect GDS to "DATA LINK CONNECTOR(DLC)".
IG key "ON", Engine "OFF".
Select "Current Data" with GDS.
Keep the vehicle condition within "the enable conditions" (Refer to "DTC Detecting Condition" table).
Monitor change of current data.
Fig 1) Normal current data
This current data is nothing but an example at certain condition. Thus, the real current data could be different from this example.
Is the displayed current data normal?
 | ▶ Fault is intermittent caused by poor contact in CLU("INSTRUMENT CLUSTER")'s connector or was repaired and CLU memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. ▶ Repair or replace as necessary, go to "Verification of Vehicle Repair" procedure. |
 | ▶ Go to "Wiring Inspection" procedure. |
