Ignition "OFF"
Disconnect the connector of temperature control actuator.
Verify that the temperature control actuator operates to the hot position when connecting 12V to the terminal 3 and grounding terminal 7
Verify that the temperature control actuator operates to the cool position when connecting in the reverse.
1. - 2. - 3. Hot position 4. Sensor ground | 5. Feedback signal 6. 5V (Vcc) 7. Cool position |
Check the voltage between terminals 4and 5 (Drive)
Door position | Voltage(4-5) | Error detecting |
Max. cooling | 0.3 ± 0.15V | Low voltage : 0.1V or less |
Max. heating | 4.7 ± 0.15V | High voltage : 4.9V or more |
1. - 2. - 3. Hot position 4. Sensor ground | 5. Feedback signal 6. 5V (Vcc) 7. Cool position |
Check the voltage between terminals 4 and 5 (Passenger)
Door position | Voltage(4-5) | Error detecting |
Max. cooling | 0.3 ± 0.15V | Low voltage : 0.1V or less |
Max. heating | 4.7 ± 0.15V | High voltage : 4.9V or more |
It will feedback current position of actuator to controls.
If the measured voltage is not specification, substitute with a known-good temperature control actuator and check for proper operation.
If the problem is corrected, replace the temperature control actuator.
Disconnect the negative (-) battery terminal.
Using the screwdriver, remove the center garnish (A).
Loosen the mounting remove the console upper cover (A).
Remove the center console assembly.
(Refer to BD group - "Center Console")
Loosen the mounting nut and clip remove the extension cover (A).
Remove the side cover (A).
Disconnect the fuse box cover (A).
Loosen the mounting screw and then remove the crash pad lower cover (B).
Disconnect the diagnosis connector (A).
After loosening the mounting bolts, then remove the reinforce panel (A).
Remove the shower duct (A).
Disconnect the temperature control actuator connector (A)
Loosen the mounting screw and then remove the temperature control actuator (B).
Remove the side cover (A).
Loosen the mounting nut and clip remove the extension cover (A)
Disconnect the guide (B), from the glove box (C) and then remove the glove box left (A).
Disconnect the pin (A) and then remove the glove box (B).
Loosen the mounting screw, and then remove the crash pad panel (A).
Loosen the mounting bolts and screws and then remove the glove box housing (A).
Remove the shower duct (A).
Disconnect the temperature control actuator connector (A)
Loosen the mounting screw and then remove the temperature control actuator (B).
Install in the reverse order of removal.
