4.
Verify that the intake actuator operates to the fresh position when connecting in the reverse.
1. - 2. - 3. Recirculation 4. 5V (Vcc) | 5. Feedback Signal 6. Sensor Ground 7. Fresh |
Ignition "OFF"
Disconnect the intake actuator connector.
Verify that the actuator operates to the recirculation position when connecting 12V to the terminal 3 and grounding terminal 7.
Verify that the intake actuator operates to the fresh position when connecting in the reverse.
1. - 2. - 3. Recirculation 4. 5V (Vcc) | 5. Feedback Signal 6. Sensor Ground 7. Fresh |
Check the voltage between terminals 5 and 6.
Door position | Voltage(5-6) | Error detecting |
Recircualtion | 0.3 ± 0.15V | Low voltage : 0.1V or less |
Fresh | 4.7 ± 0.15V | High voltage : 4.9V or more |
If the intake actuator is not operated well, substitute with a known-good intake actuator and check for proper operation.
If the problem is corrected, replace the intake actuator.
Disconnect the negative (-) battery terminal.
Remove the crash pad.
(Refer to BD group - "Crash Pad")
Disconnect the Intake actuator connector (A).
Loosen the mounting screw and then remove the intake actuator (B).
Install in the reverse order of removal.
