Turn the ignition switch OFF, and then remove battery (-) cable.
Release the residual pressure in fuel line.
(Refer to Fuel Delivery System - “Release Residual Pressure in Fuel Line”)
Disconnect the fuel feed tube quick-connecotr (A).
Disconnect the vapor hose (A) which is connected from the PCSV.
Disconnect the fuel pump connector (A) and fuel feed quick-connector (B) from the fuel pump.
Disconnect the vapor tube quick-connector (C).
Lift the vehicle.
Remove the fuel tank.
(Refer to Fuel Delivery System - " Fuel Tank")
Remove the vapor tube and low fuel line fixing clip (A) using driver.
Release the fuel & brake line protect (A) from the fixing clip.
Remove the fuel feed line fixing clip (A) from engine room lower.
Remove the fuel line (A).
Do not use already used injector fixing clip again.
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
Install in the reverse order of removal.