Inspection
Clutch Pedal Inspection
1.

Measure the clutch pedal height (from the face of the pedal pad to the floor board) and the clutch pedal clevis pin play (measured at the face of the pedal pad.)

Standard value

Stroke (A) :

Gasoline :140 ± 0.3 mm (5.5118 ± 0.0118 in.)

Diesel :150 ± 0.3 mm (5.9055 ± 0.0118 in.)

Height (C) : 189.1 mm (7.4449 in.)

Removal
note

Do not spill brake fluid on the vehicle; it may damage the paint if brake fluid does contact the paint, wash it off immediately with water.

1.

Remove the battery.

(Refer to Engine Electrical System - "Battery")

2.

Remove the ECM.

(Refer to Engine Control System - "ECM")

3.

Disconnect the clutch tube (B) and reservoir hose (A) from the clutch master cylinder.

4.

Disconnect the push rod from the master cylinder by removing the snap pin (A) and washer (B).

5.

Remove the clutch pedal mounting bolt (A) and nuts (B-2ea).

Tightening torque:

(A) 16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~ 18.8 lb-ft)

(B) 18.6 ~ 23.5 Nm (1.9 ~ 2.4 kgf.m, 13.7 ~ 17.4 lb-ft)

6.

Disconnect the ignition lock switch connector (C) and clutch switch connector (D).

7.

Remove the clutch pedal and the master cylinder assembly together.

Installation
1.

Install in the reverse order of removal.

note

Perform bleeding air procedure in clutch release cylinder after pouring the brake fluid.

(Refer to Clutch System - "Clutch Release Cylinder ")

Яндекс.Метрика