1.
Remove the glass (A) by lifting it up.
note
●
Do not damage the roof panel.
Put on glove to protect your hands.
Remove the glass (A) by lifting it up.
Do not damage the roof panel.
Installation is the reverse of removal.
Remove the roof trim.
(Refer to the BD group - "Roof Trim")
Disconnect the connector (B).
Remove the motor after removing screws from the motor (A).
Installation is the reverse of removal.
Make sure to initilize the motor.
Open the glass fully.
Disconnect the deflector link (A) from the frame (B), and then remove the deflector (C).
Installation is the reverse of removal.
Remove the follows parts.
Front seat
(Refer to the BD group - "Front Seat")
Rear seat
(Refer to the BD group - "Rear Seat")
Interior trim
(Refer to the BD group - "Interior Trim")
Roof trim
(Refer to the BD group - "Roof Trim")
After loosening the mounting bolts, then remove the assist handle bracket
Disconnect the drain tubes (B).
After loosening the mounding nuts, remove the sunroof assembly (A).
Tightening torque :
3.9~5.9 N.m (0.4~0.6 kgf.m, 2.9~4.3 lb-ft)
Installation is the reverse of removal.
Remove the sunroof assembly.
Remove the drip link (A) and sunshade stopper (B).
Remove the sunshade (C) and drip rail (D).
Installation is the reverse of removal.
Remove the sunroof assembly.
Remove a guide assembly (A) after lowering a guide thoroughly by pushing a slide to rear.
Remove the guide (A) and slide (B).
Installation is the reverse of removal.
Make sure to align the slide with the center of “A” and “B”
Make sure to initialize the motor.
