Installation is the reverse of removal.
After completing the installation perform the following procedure;
Adjust the shift cable.(Refer to "Automatic transaxle control system (Shift lever)" in this group)
Refill the transaxle fluid. (Refer to "Repair procedures" in this group)
Clean the battery posts and cable terminals with sandpaper and grease them to prevent corrosion before installing.
When replacing the automatic transaxle, reset the automatic transaxle's values by using the High- Scan Pro or GDS.
Connect the Hi-Scan Pro or GDS connector to the data link connector under the dash pad and power cable to the cigar jack under the center facia.
Turn the ignition switch on and power on the Hi-Scan Pro.
Select the vehicle's name.
Select 'AUTOMATIC TRANSAXLE'.
