Many malfunctions in the electrical system are caused by poor harness and terminals. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.

Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.

Has a problem been found?

	▶ Repair as necessary and go to "Verification of vehicle Repair" procedure.
	▶ Go to "PCSV circuit inspection" procedure.

IG KEY "OFF".

Disconnect PCSV connector.

IG KEY "ON" & ENG "OFF"

Measure the voltage between power terminal of PCSV harness connector and chassis ground.

Is the measured voltage within specification ?

	▶ Go to "Control circuit inspection" procedure.
	▶ Repair Open or Short to ground circuit and then, go to "Verification of Vehicle Repair" procedure.

IG KEY "OFF".

Disconnect PCSV connector.

IG KEY "ON" & ENG "OFF"

Measure the voltage between control terminal of PCSV harness connector and chassis ground.

Is the measured voltage within specification ?

	▶ Go to "Component Inspection" procedure.
	▶ Repair Open circuit and then, go to "Verification of Vehicle Repair" procedure.