Component Inspection
■ Mil System check
1.

IG KEY "OFF".

2.

Disconnect ECM connector.

3.

Short warning lamp control terminal of ECM harness connector to Ground.

Specification : MIL ON.

note
To view Flash content, you need to install the appropriate browser extension
4.

Is the Engine MIL lamp lighting normally?

▶ Many malfunctions in the electrical system are caused by poor harness(es) and terminals. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage. So, check poor connections and the related circuit between ECM and component thoroughly. Repair as necessary and go to "Verification of Vehicle Repair" procedure.

▶ Substitute with a known-good Cluster and check for proper operation.If the problem is corrected, replace Cluster and then go to "Verification of Vehicle Repair" procedure.

Яндекс.Метрика