Many malfunctions in the electrical system are caused by poor harness and terminals. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.

Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.

Has a problem been found?

	▶ Repair as necessary and go to "Verification of vehicle Repair" procedure.
	▶ Go to "CMPS Power circuit inspection" procedure.

IG KEY "OFF".

Disconnect CMPS connector.

IG KEY "ON" & ENG "OFF"

Measure the voltage between power terminal of CMPS harness connector and chassis ground.

Is the measured voltage within specification ?

	▶ Go to "Signal circuit inspection" procedure.
	▶ Repair Open or Short circuit and then, go to "Verification of Vehicle Repair" procedure.

IG KEY "OFF".

Disconnect CMPS connector.

IG KEY "ON" & ENG "OFF"

Measure the voltage between signal terminal of CMPS harness connector and chassis ground.

Is the measured voltage within specification ?

	▶ Go to "Short to power circuit inspection" procedure.
	▶ Repair Open in signal circuit and then, go to "Verification of Vehicle Repair" procedure.

IG KEY "OFF".

Disconnect CMPS connector and ECM connector.

Measure the resistance between power and signal terminal of CMPS harness connector.

Is the measured resistance within specification ?

	▶ Go to "Ground circuit inspection" procedure.
	▶ Repair Short to power in signal circuit and then, go to "Verification of Vehicle Repair" procedure.

IG KEY "OFF".

Disconnect CMPS connector.

IG KEY "ON" & ENG "OFF"

Measure the voltage between signal terminal of CMPS harness connector and chassis ground.(A)

Measure the voltage between signal and ground terminal of CMPS harness connector and chassis ground.(B)

Is the measured voltage within specification ?

	▶ Go to "Component Inspection" procedure.
	▶ Repair Open in ground circuit and then, go to "Verification of Vehicle Repair" procedure.