Component Inspection
■ ETC Initialization (Adaptation procedure)
1.

IG "OFF".

2.

After the main relay is snapped, IG "ON". (Keep IG "ON" at least 30sec.)

3.

After the adaptation procedure, Is parameter displayed within specifications?

▶ This code is occured by ETC's adaptation error.

After erase the code, go to "Verification of Vehicle Repair" procedure.

▶ Substitute with a known - good ETC motor and check for proper operation. If the problem is corrected, replace ETC motor and go to "Verification of Vehicle Repair" procedure.

Яндекс.Метрика