Many malfunctions in the electrical system are caused by poor harness and terminals. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.

Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.

Has a problem been found?

	▶ Repair as necessary and go to "Verification of Vehicle Repair" procedure.
	▶ Go to "Power Circuit Inspection" procedure.

IG KEY "OFF".

Disconnect MAPS connector.

IG KEY "ON" & ENG "OFF"

Measure the voltage between power terminal of MAPS harness connector and chassis ground.

Is the measured voltage within specification ?

	▶ Go to "Signal circuit inspection" procedure.
	▶ Check for Open or Short to ground in TPS circuit. Repair as necessary and then go to "Verification of Vehicle Repair" procedure.

IG KEY "OFF".

Disconnect MAPS connector.

IG KEY "ON" & ENG "OFF"

Measure the voltage between signal terminal of MAPS harness connector and chassis ground.

Is the measured voltage within specification ?

	▶ Go to "Component inspection" procedure.
	▶ Repair Short to ground in signal circuit and go to "Verification of Vehicle Repair" procedure.