▶ Check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure.
▶ Go to "Component Inspection" procedure.
Ignition "ON" & Engine "OFF".
Check if immobilizer lamp operates properly.
Right after ignition "ON", Immobilizer lamp lights up for 30sec.
If lamp blinks 5 times after ignition "ON", a fault exists in immobilizer system.
Is the immobilizer lamp operating properly ?
| ▶ Check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure. |
| ▶ Go to "Component Inspection" procedure. |
IG KEY OFF.
Connect SMARTRA connector and disconnect ECM connector.
Ground indicator terminal of ECM harness connector with wire.
IG KEY ON & Engine "OFF".
Specification : Immobilizer lamp "ON"
Is the Immobilizer lamp "ON" ?
| ▶ Substitute with a known-good ECM and check for proper operation. ▶ If the problem is corrected, replace ECM and then go to "Verification of Vehicle Repair" procedure. note ECM substitued for old one must be in "Virgin" or "Neutral" status and Pin code is requied to Neutralize ECM and to Register transponder key |
| ▶ Check that fuse has blown off and harness between ECM connector and Battery is in normal condition. And. check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure. |
