3.
Monitor the "ECU, KEY and Smartra STATUS" Parameter on the Scantool.
Specification : 'LEARNT'
Fig.1) This data show that 3 keys have been taught, ECU has been learnt, the Key in key cylinder has been learnt and SMARTRA3 has been learnt.
Connect scantool to Data Link Connector(DLC).
IG "ON" & Engine "OFF".
Monitor the "ECU, KEY and Smartra STATUS" Parameter on the Scantool.
Specification : 'LEARNT'
Fig.1) This data show that 3 keys have been taught, ECU has been learnt, the Key in key cylinder has been learnt and SMARTRA3 has been learnt.
Has the "Smartra STATUS' been learnt ?
 | ▶ Check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, damage on the PCM/ECM or SMARTRA. And this DTC has not erased in previous repair. Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure. |
 | ▶ Go to "Inspection & Repair" procedure. |
