1.
Check status.
(1)
IGN "ON" & Engine "OFF".
(2)
Monitor the "ECM, Key and Smartra Status" Parameter on the Scantool.
Specification : 'LEARNT'
Fig.1) This data show that 3 keys have been taught, ECU has been learnt, Key in key cylinder has been learnt and SMARTRA3 has been learnt.
(3)
Are "KEY STATUS", "SMARTRA STATUS" and "ECU STATUS" Parameter within specifications ?
 | ▶ Fault is intermittent caused by poor contact in the ECM or SMARTRA connector or was repaired and ECM memory was not cleared. Throughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration or damage.Repair or replace as necessary and go to "Verification Vehicle Repair" procedure. |
 | ▶ Go to "Component Inspection" Procedure. |
