Many malfunctions in the electrical system are caused by poor harness and terminal connections.

Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.

Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.

Has a problem been found ?

	▶ Repair as necessary and go to "Verification Vehicle Repair" procedure.
	▶ Go to "Signal Circuit Inspection" procedure.

IG KEY OFF.

Disconnect Engine ECM connector.

IG KEY "ON".

Measure voltage between signal terminal of ECM harness connector and chassis ground.

Is the measured voltage within specification ?

	▶ Go to "Component Inspection" procedure.
	▶ Check open or short to signal circuit and then, go to "Verification of Vehicle Repair" procedure.