Seat Belt Pretensioner(hereinafter referred to BPT) is located at both side of center pillar.
BPT tightens seat belt before air bag deploys to protect passenger from bumping against crush pad, steering wheel and front window.
In BPT, there are a ignition circuit and cylinder for rewinding belt.
Cylinder has piston that can rewind seat belt in it.
Gas chamber generates expansive force of gases to push piston in cylinder.
Never measure resistance of BPT directly, Current of measuring device may cause unexpected BPT depoy.
The SRSCM sets DTC B1362 if the measured resistance value of DBPT circuit is less than the threshold value.
*In this case, SRSCM checks if there's any fault in circuit by sending current for a while.
Item | Detecting Condition | Possible cause | |
DTC Strategy |
•
Check Resistance | 1. Poor connection of connected part. 2. Poor connection between shorting bar and release pin. 3. Faulty DBPT. 4. Faulty SRSCM. | |
Enable Conditions |
•
Ignition "ON" | ||
Threshold Value |
•
DBPT resistance ≤ 1.5Ω | ||
Diagnostic Time | Qualification |
•
More than 1s (100ms x 10) | |
De-Qualification |
•
More than 2s(100ms x 20) | ||
Test Condition | Resistance |
Ignition ON | 1.5Ω ≤ Squib resistance ≤ 6Ω |
