3.
Monitor the "Battery Voltage" parameter on the Scantool.
Specification : Approx. 8 ≤ Vbatt ≤ 16
Fig.1) Normal Data
Ignition "OFF", connect scantool.
Ignition "ON"& Engine "OFF", select "Current Data" mode.
Monitor the "Battery Voltage" parameter on the Scantool.
Specification : Approx. 8 ≤ Vbatt ≤ 16
Fig.1) Normal Data
Is parameter displayed within specifications?
 | ▶ Displaying nothing(no DTC) or DTC with label "H"(historical) shows that Fault is intermittent caused by poor contact in the part's and/or SRSCM connector or was repaired and SRSCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. ▶ Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure. |
 | ▶ Go to "W/Harness Inspection" procedure. |
