Component Inspection
1.

IG "OFF"

2.

IG "ON"

3.

After connecting GDS, check DTC on the GDS.

4.

Using GDS, Erase the DTCs.

5.

Using a GDS, Check DTC present.

6.

Is the same DTC shown?

▶ Substitute with a known-good Yaw rate sensor and check for proper operation. If problem is corrected, replace Yaw rate sensor and then go to "Verification of Vehicle Repair" procedure.

※ In a case of replacing the Yaw rate sensor, operate "longitudinal G sensor Calibration" by GDS. (DBC/HAC only, refer to C1285)

▶ Fault is intermittent caused by poor connection in Yaw rate sensor harness or faulty Yaw rate sensor. Go to "Verification of Vehicle Repair" procedure

Яндекс.Метрика