4.
Monitor the "STEERING SNSR" parameters on the GDS.
Specification : If the parameters are changed according to wheel position during steering
the wheel, it is normal condition.
Fig 1) Test Condition : Ignition "ON" & Engine "ON".
Normal Data
Connect GDS to Data Link Connector(DLC).
IG "ON", ENG "ON".
Turn the steering wheel to the left or right.
Monitor the "STEERING SNSR" parameters on the GDS.
Specification : If the parameters are changed according to wheel position during steering
the wheel, it is normal condition.
Fig 1) Test Condition : Ignition "ON" & Engine "ON".
Normal Data
Whenever steering wheel is turned, is the steering sensor's scantool data changed?
 | ▶ Fault is intermittent caused by poor connection in steering sensor harness and/or HECU's connector or was repaired and HECU memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure. |
 | ▶ Go to "Terminal and Connector Inspection" procedure. |
