8437608

Measure voltage between signal terminal of the steering angle sensor harness connector and chassis ground.

Specification : HIGH : 2.9±0.1V ~ 4.4±0.1V, LOW : 1.2±0.1V ~ 2.1±0.1V

note

To view Flash content, you need to install the appropriate browser extension

Is the measured value within specifications?

	▶ Fault is intermittent caused by poor connection in steering sensor harness and/or HECU's connector. Go to "Verification of vehicle Repair" procedure.
	▶ Substitute with a known-good steering angle sensor and check for proper operation. If problem is corrected, replace steering angle sensor and then go to "Verification of Vehicle Repair" procedure.