Ignition "OFF"
Disconnect Evaporator sensor and Connect A/C control Module main harness connector.
Measure resistance between Signal(+) terminal of Evaporator sensor harness connector and Sensor ground harness connector. (Component side)
Specification : Refer the specifications in Fig.1)
Temperature(℃/℉) | Resistance(㏀) | Temperature(℃/℉) | Resistance(㏀) |
-4/-24.8 | 13.6 | 4/39 | 9.5 |
-2/28 | 12.4 | 6/42 | 8.7 |
0/32 | 11.3 | 8/46 | 8 |
2/35 | 10.3 | 10/50 | 7.3 |
Fig.1) Resistance value of Evaporator sensor as a function of temperature.
Is "resistance" display near the specified value?
 | ▶ Go to Next procedure. |
 | ▶ Substitute with a known-good Evaporator sensor and check for proper operation. If the problem is corrected, replace Evaporator sensor and then go to "Verification of Vehicle Repair" procedure. |
Ignition "OFF"
Disconnect Evaporator sensor and Connect A/C control Module main harness connector.
Ignition "ON"(ENGINE "OFF").
Measure voltage between Signal(+) terminal of Evaporator sensor harness connector and chassis ground. (Component side)
Specification : approx. 5V
Is "voltage" display near the specified value?
| ▶ Check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure. |
| ▶ Substitute with a known-good A/C control Module and check for proper operation. If the problem is corrected, replace A/C control Module and then go to "Verification of Vehicle Repair" procedure. |
