Remove the following items;
Hood (Refer to "Interior (Hood)" in BD group)
Cowl complete assembly panel (A).
Air cleaner assembly and air duct (B) . (Refer to "Intake and Exhaust system" in EM group.)
Battery and battery tray (C). (Refer to "Charging system" in EE group.)
ECM (D) (Refer to "Engine Control System" in FL group.)
Disconnect the cable assembly (C) after removing the clips (B) and pins (A).
The clips use new one.
Disconnect the back up lamp switch connector (A) and the vehicle speed sensor connector (B).
Remove the ground cable from transaxle (A).
Remove the tube bracket bolt (A).
Tightening torque:
14.7 ~ 21.6 N.m (1.5 ~ 2.2 kgf.m, 10.8 ~ 15.9 lb-ft)
Remove the transaxle upper mounting bolt (A-2ea) and the start motor mounting bolt (B-2ea).
Tightening torque:
(A) 42.2 ~ 54.0 N.m(4.3 ~ 5.5 kgf.m, 31.1 ~ 39.8 lb-ft)
(B) 38.2 ~ 58.8 N.m (3.9 ~ 6.0 kgf.m, 28.2 ~ 43.4 lb-ft)
Using the engine support fixture (Support SST No.: 09200-2S000, Beam SST No.: 09200-38001), hold the engine and transaxle assembly safely.
Remove the transaxle support bracket bolts (A-3ea).
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
Remove the under cover (A).
Remove the clutch release cylinder assembly (B) after removing the nuts (A-2ea)
Tightening torque:
14.7 ~ 21.6 N.m (1.5 ~ 2.2 kgf.m, 10.8 ~ 15.9 lb-ft)
Remove the brackets (A).
Remove the roll rod bracket (C) after removing bolt (A,B).
Tightening torque:
(A) 49.0 ~ 63.7 N.m (5.0 ~ 6.5 kgf.m, 36.2 ~ 47.0 lb-ft)
(B) 107.9 ~ 127.5 N.m (11 ~ 13 kgf.m, 79.6 ~ 94.1 lb-ft)
Remove the plastic dust cover (A).
Remove the drive shaft assembly. (Refer to "Drive shaft assembly" in DS group.)
Remove the mounting bolts (A-3ea, B-2ea) of lower part of the transaxle, and the left side cover and remove the transaxle assembly by supporting it with a jack.
Be careful not to damage other system or parts near by when removing the engine and transaxle assembly.
Tightening torque:
(A) 42.2 ~ 48.1 N.m (4.3 ~ 4.9 kgf.m, 31.1 ~ 35.4 lb-ft)
(B) 42.2 ~ 53.9 N.m (4.3 ~ 5.5 kgf.m, 31.1 ~ 39.8 lb-ft)
Installation is the reverse of removal.
Adding Manual transaxle fluid. (Refer to "Manual transaxle system" in this group.)
