1.
After loosening the mounting screws, then remove the sunvisor (A) and retainer (B).
When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
Put on gloves to protect your hands.
After loosening the mounting screws, then remove the sunvisor (A) and retainer (B).
Installation is the reverse of removal.
When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
Put on gloves to protect your hands.
Remove the covers (B)
After loosening the mounting bolts, then remove the assist handle (A).
Installation is the reverse of removal.
When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
Put on gloves to protect your hands.
After loosening the mounting screws, then remove the overhead console assembly (A).
Disconnect the connectors (A).
Installation is the reverse of removal.
Make sure the connector is connected properly.
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Put on gloves to protect your hands.
Remove the following items.
Front seat
(Refer to the BD group - "Front Seat")
Rear seat
(Refer to the BD group - "Rear Seat")
Sunvisor
Overhead console
Assist handle
Front pillar trim
(Refer to the BD group - " Interior Trim")
Front door scuff trim & Rear door scuff trim
(Refer to the BD group - " Interior Trim")
Center pillar lower trim & Center pillar upper trim
(Refer to the BD group - " Interior Trim")
Rear pillar trim
(Refer to the BD group - " Interior Trim")
Rear wheelhousing trim
(Refer to the BD group - " Interior Trim")
Floor console
(Refer to the BD group - "Console")
Remove the ECM mirror cover (A).
Disconnect the ECM mirror connector (B).
Disconnect the connectors (A) and then mounting clips in front pillar.
Remove the clips and roof trim (A).
Installation is the reverse of removal.
Replace any damage clips.
