3.
After loosening the mounting bolt, then remove the front seat belt lower anchor (B).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
When installing the belt, make sure not to damaged the pretensioner.
Remove the following items first.
Front seat assembly
(Refer to the BD group – “Front Seat”).
Front door scuff trim and rear door scuff trim
(Refer to the BD group – “Interior Trim”).
Remove the front seat belt lower anchor cover (A).
After loosening the mounting bolt, then remove the front seat belt lower anchor (B).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
Using a screwdriver or remover, remove the center pillar lower trim (A).
After loosening the mounting bolt, then remove the center pillar upper trim (A).
Loosen the mounting bolt, then remove the front seat belt upper anchor (A).
Tightening torque :
39.2~53.9 N.m (4.0~5.5 kgf.m, 28.9~39.8 lb-ft)
After disconnecting the pretensioner connector lock pin, remove the BPT connector (A), Loosening the mounting bolt, then remove the pretensioner (B).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
Installation is the reverse of removal.
Remove the following items first:
Front door scuff trim and rear door scuff trim
(Refer to the BD group – “Interior Trim”).
Front seat belt lower anchor.
Center pillar lower trim.
(Refer to the BD group – “Interior Trim”).
Center pillar upper trim
(Refer to the BD group – “Interior Trim”).
Front seat belt upper anchor.
After loosening the bolts, then remove the hight adjustor (A).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
Installation is the reverse of removal.
Replace any damaged clips.
Make sure the height adjust properly.
Remove the following items first:
Front seat assembly
(Refer to the BD group – “Front Seat”).
After loosening the mounting screws, then remove the front seat track side cover (A).
Disconnect the connect (A) mounting clip.
After loosening the mounting bolt, then remove the front seat belt buckle (A).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
Installation is the reverse of removal.
