5.
Remove the output speed sensor connector(A).
Remove the battery terminal.
Remove the battery and battery tray. (Refer to "Charging System" in EE group)
Remove the air duct. (Refer to "Intake and Exhaust System" in EM group)
Remove the air cleaner assembly. (Refer to "Automatic transaxle" in this group)
Remove the output speed sensor connector(A).
Remove the output speed sensor(A).
Install the new O-ring to the output shaft speed sensor.
Remove the output speed sensor (A).
Tightening torque :
10 ~ 12 N.m (1.0 ~ 1.2 kgf.m, 7 ~ 8 lb-ft)
While installing the output speed sensor, do not allow dust or other foreign particles to enter the transaxle.
Check the connector for dust, dirt, or oil, then connect the output speed sensor connector (A) securely.
Installation is the reverse of removal.
