1.
Disconnect the push rod from the master cylinder by removing the snap pin (A) and washer.
Do not spill brake fluid on the vehicle; it may damage the paint if brake fluid does contact the paint, wash it off immediately with water.
Disconnect the push rod from the master cylinder by removing the snap pin (A) and washer.
Remove the clutch pedal mounting nuts (A-3ea).
Tightening torque:
12.7 ~ 15.7 N.m (1.3 ~ 1.6 kgf.m, 9.4 ~ 11.6 lb-ft)
Remove the Battery.
(Refer to Engine Electrical System - "Battery")
Remove the ECM.
(Refer to Engine Control System - "ECM")
Disconnect the clutch tube (B) and reservoir hose (A) from the clutch master cylinder.
Remove the clutch master cylinder bracket (A) in the arrow direction.
Remove the clutch master cylinder (A) from the bracket by turning it clockwise.
Install in the reverse order of removal.
Perform bleeding air procedure in clutch release cylinder after pouring the brake fluid.
(Refer to Clutch System - "Clutch Master Cylinder")
