3.
Disconnect the connectors from the actuator.
Remove the front door trim.
(Refer to Body - "Front Door")
Remove the front door latch.
(Refer to Body - "Front Door")
Disconnect the connectors from the actuator.
Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.
Remove the rear door trim.
(Refer to Body - "Rear Door")
Remove the rear door latch.
(Refer to Body - "Rear Door")
Disconnect the connectors from the actuator.
Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.
Remove the front door trim.
(Refer to Body - "Front Door")
Remove the front door latch.
(Refer to Body - "Front Door")
Disconnect the connectors from the actuator.
Check for continuity between the terminals in each switch position when inserting the key into the door according to the table.
Remove the rear door trim.
(Refer to Body - "Rear Door")
Remove the rear door latch.
(Refer to Body - "Rear Door")
Disconnect the connectors from the actuator.
Check for continuity between the terminals in each switch position according to the table.
Disconnect the negative battery terminal.
Remove the rear trunk lid trim, and then remove the trunk lid switch from the actuator.
Check for continuity between the terminals in each switch position according to the table.
Remove the door switch and check for continuity between the terminals.
Remove the steering column upper and lower shrouds after removing 3 screws.
Disconnect the 6P connector from the door warning switch.
Check for continuity between the terminals in each position according to the table.
