4.
Remove the shift cable (A) and select cable (B) after removing the pin (C-2ea).
Set shift lever to N position.
Remove the air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
Remove the shift cable (A) and select cable (B) after removing the pin (C-2ea).
Remove the control shaft assembly after loosen the bolts.
Tightening torque:
19.6 ~ 26.5 N.m (2.0 ~ 2.7 kgf.m,14.5 ~ 19.5 lb-ft)
Install in the reverse order of removal.
When installing, set control shaft lever to neutral position.
When installing, apply the sealant as shown in the illustration.
Specified sealant : MS 721-40 or MS721-38
Check operating of lever of transaxle side when operating shift lever after assembly. (1~6,R)
