3.
Compare with under the table.
- Start a vehicle ,Verify terminated diagnosis of parts ,which is fixed properly.
- Remove all displayed DTC and then check for trouble code again
After connecting Scantool and Monitor the " ENGINE SPEED,INPUT SPEED SENSOR, DAMPER CLUTCH SOL DUTY and DAMPER CLUTCH SLIP " parameter on the Scantool data list.
After DAMPER CLUTCH is operated , Measure data when output-speed is more than 1000RPM and DCC Solenoide DUTY is 0%
Compare with under the table.
- Start a vehicle ,Verify terminated diagnosis of parts ,which is fixed properly.
- Remove all displayed DTC and then check for trouble code again
Monitoring for (pending) DTC. Is DTC P0742 set?
YES
Go to the applicable troubleshooting procedure.
NO
System OK
